Question
Fri June 08, 2012 By: Anjali

# induction

Mon June 11, 2012

Electromagnetic Induction was first discovered way back in the 1830's by Michael Faraday. Faraday noticed that when he moved a permanent magnet in and out of a coil or a single loop of wire it induced an ElectroMotive Force or emf, in other words a Voltage, and therefore a current was produced. So what Michael Faraday discovered was a way of producing an electrical current in a circuit by using only the force of a magnetic field and not batteries. This then lead to a very important law linking electricity with magnetism, Faraday's Law of Electromagnetic Induction. So how does this work?.

When the magnet shown below is moved "towards" the coil, the pointer or needle of the Galvanometer, which is basically a very sensitive centre zeroed moving-coil ammeter, will deflect away from its centre position in one direction only. When the magnet stops moving and is held stationary with regards to the coil the needle of the galvanometer returns back to zero as there is no physical movement of the magnetic field. When the magnet is moved "away" from the coil in the other direction, the needle of the galvanometer deflects in the opposite direction with regards to the first indicating a change in polarity. Then by moving the magnet back and forth towards the coil the needle of the galvanometer will deflect left or right, positive or negative, relative to the directional motion of the magnet.

how much voltage (emf) can be induced into the coil using just magnetism. Well this is determined by the following 3 different factors.

• 1). Increasing the number of turns of wire in the coil. - By increasing the amount of individual conductors cutting through the magnetic field, the amount of induced emf produced will be the sum of all the individual loops of the coil, so if there are 20 turns in the coil there will be 20 times more induced emf than in one piece of wire.
•
• 2). Increasing the speed of the relative motion between the coil and the magnet. - If the same coil of wire passed through the same magnetic field but its speed or velocity is increased, the wire will cut the lines of flux at a faster rate so more induced emf would be produced.
•
• 3). Increasing the strength of the magnetic field. - If the same coil of wire is moved at the same speed through a stronger magnetic field, there will be more emf produced because there are more lines of force to cut.
Related Questions
Tue September 20, 2016

Thu May 26, 2016

Home Work Help