Question
Thu December 01, 2011 By:

# explain the mechanism of rolling friction.

Fri December 02, 2011

The frictional force, f, the force required to slow the wheel produces a torque which tends to decrease the angular velocity, w. (The normal and gravitational forces produce no effect because their line of action is through the center of rotation.)  However, the surface could not possibly have such an effect on the wheel once the wheel has achieved pure rolling motion and constant angular and linear velocity.  Zero friction occurs only for horizontal motion at constant velocity, but it is non-zero for any case in which acceleration is occurring parallel to the direction of motion of the center of mass, as when the object is rolling-without-slipping up or down a sloped surface.  If we consider the rotation as being about the center of mass of the object, then the frictional force must be in a direction to provide the torque necessary to decrease or increase the angular velocity, depending on whether the object is accelerating or decelerating, respectively.  Note that the friction can be in the direction of motion (rolling downhill) or opposite to  it (rolling uphill).  In pure rolling motion there is no sliding or slipping, thus the contact points have no relative motion (no relative velocity). This results in a frictional force of zero.  Therefore, the wheel will roll forward with constant velocity, v = Rw, where R is the radius of the wheel.

In the actual case of the rolling wheel, the free-body diagram is much different.  Both the wheel and the surface will undergo deformations due to their particular elastic characteristics.  At the contact points, the wheel flattens out while a small trench is formed in the surface.  The normal force is now distributed over the actual contact area rather than the point just below the center of the wheel.

Furthermore, the wheel takes on a sort of plowing motion resulting in increased deformation at the front of the wheel, while the rear of the wheel undergoes little deformation which results in the majority of the normal force being located at the front.  When the wheel and the surface deform there is a minute amount of slipping, but the majority of the force is due to static friction.  The overall rolling friction results in a force at the center of the wheel and is parallel to the surface of contact, and is represented by the equation:

Related Questions
Sat May 13, 2017

Fri May 12, 2017

Home Work Help